Draw Bridge shaft alignment

Draw Bridge shaft alignment

Task: To make sure the inboard and outboard bores are in-line with one another. Make legs to fit 36” diameter hole and set up for laser to pass through on centerline. Issues: Since the job had to be competed outside we had to cover the bridge weldment with a tarp to...
72 Meter Gantry Mill

72 Meter Gantry Mill

Task: To check alignment, flatness, straightness, and parallelism of both X axis rails. Issues: The machine could not be run over 50% federate or it would fault out.   What we found:  Using our Hamar L-723 laser we shot into the travel of the X axis on the master side...